Level 1 Diagnostics (Setup Mode)

Use the Level 1 diagnostics or setup mode to change the settings for various printer functions and to run certain tests. When changing the settings, keep the following information in mind:

•The settings can only be changed when the printer is in level 1 diagnostics: Switch 1 must be set to On and Switch 2 must be set to Off.

•The default options are set at the factory and are stored in the history EEROM.

•Once the settings have been changed and stored in the EEROM, the DIP switches (switch 1 and 2 set to off) must be set back to the online settings for the printer to operate.

Caution:  When changing the printer settings, be sure that they are the correct settings for that particular function or test to avoid accidentally changing the settings for another function or test. If the settings are accidentally changed, re–enter the setup mode and the correct settings. If assistance is needed, contact a service representative. For more information, refer to Contacting a Service Representative.