Installing the Display

Caution:  Due to its weight, installing the Display requires at least two persons.

For Dual-Sided Kiosk configuration, there are two Displays that need to be installed to the kiosk. Perform the procedure on each side of the kiosk to install both Displays.

To install the Display, perform the following steps:

1.Remove the Indicator Light and Camera cables from the cable clamp securing it to the Door Top Panel.

2.Remove the Camera assembly from the kiosk by removing two M4 nuts.

3.Remove the black plastic Indicator Light Cover from the Top Panel.

4.Remove the Indicator Light assembly from the kiosk by removing two M4 nuts.

5.Loosen the two M4 nuts securing the Top Panel.

6.Remove the Top Panel by removing three M4 flat head screws.

7.Partially tighten two M6 screws on the two mounting holes near the round air vent of the Display.

8.While supporting the Display on the front and rear side, mount the Display on the kiosk.

a.At an angle, insert the bottom part of the display into the Kiosk Door Frame.

b.Rotate the top part of the Display into the kiosk, inserting the partially mounted screws through the keyhole slots on the door panel and then slowly slide the Display down until it rests on the kiosk.

9.Partially install two M6 screws on the bottom mounting holes of the display. Use the handles to make alignment adjustments and then tighten all four M6 screws to secure the display.

10.Mount the Top Panel to the kiosk by hooking the bracket on studs with partially installed nuts, and then tighten the nuts.

11.Secure the Top Panel using three M4 flat head screws.

12.Install the Indicator Light assembly to the kiosk.

a.Mount and secure Indicator Light assembly using the two M4 nuts.

b.Secure the Indicator Light and MEI SIL/LIL cables to the cable clamps on the door. Make sure that the indicator light is connected to the appropriate MEI cable connector.

•Connect White Indicator Light to 3-pin MEI cable connector.

•Connect Tri-Color Indicator Light to 4-pin MEI cable connector.

13.Install the Camera assembly to the kiosk.

a.Insert the black plastic Indicator Light Cover under the Indicator Light, mounting its slots over the two studs on the Top Panel.

b.Mount and secure the Camera assembly using two M4 nuts.

14.Secure the Indicator Light and Camera cables to the cable clamp on the Top Panel.