Changing Bottom-of-Basket Camera Orientation

To change the orientation of the Bottom-of-Basket Camera, follow these steps:

Note:  This procedure should be done only when changing the orientation of the Large Basket Angled Module (V-Bagwell). For the purpose of illustration only, this procedure shows images converting a Left-hand (LH) orientation to a Right-hand (RH) orientation.

1.Change the orientation of the Large Basket Angled Module (V-Bagwell), if necessary. For more information, refer to 7358-K589/K590/K591 Large Basket Angled Module Kit Instructions.

2.Remove the Camera assembly and blanking plate that are installed inside the Bagwell by doing the following:

•Remove two (2) nuts to detach the Camera blanking plate from the Bagwell wall, as shown in the image below.

• Remove two (2) nuts to detach the Camera assembly from the Camera mounting hole.

3.Install the Camera assembly and blanking plate inside the Bagwell by doing the following:

•Secure the Camera assembly to the Camera mounting hole on the other side of the V-Bagwell using two (2) nuts, as shown in the image below.

•Install the Camera blanking plate on the empty Camera mounting hole on the Bagwell wall.

4.Route the cable to the SelfServ Checkout unit through the cable access holes of the Bagwells, as shown in the image below.

5.Depending on the SelfServ Checkout unit, connect the other end of the cable to the corresponding ports. Refer to the table below for the location of the ports.