Removing Hoppers

To remove an existing Hopper, follow these steps:

Note

To convert a Non-Rounding System to a Rounding System, replace the existing Type A Hoppers with four (4) Type B Hoppers.

  1. Access the CR5000 Coin Recycler (cpi™).
  2. Unlock the Coin Recycler and then raise the locking bar.

    Note

    When the locking bar is lifted to access the hoppers, the power is automatically turned off to these modules.

  3. Remove a hopper by tilting it and then lifting it up and out using the green handle as shown below.