Routing the Tri-Light/Lane Light Cable on a Fixed unit

To route the Terminal Display cables, follow these steps:

1. Do the following:
   1. From the Tower Frame pole duct, route the Tri-Light/Lane Light cable down through the built-in hooks inside the Tower Frame.
   2. Route the cable down the Scanner Bucket floor. Use cable ties to secure the cable on bridge lances.
   3. Secure the cable to the anchor using a cable tie.

      

2. From the corner cable access hole, route the cable down the Core Cabinet wall and connect to the I/O Box (Tri-Light/Lane Light port). Use cable ties to secure the cable on bridge lances.
   Note

   For the Tri-Light/Lane Light with Camera Assembly, connect the Camera Power cable to the I/O Box (Input Belt port).