Removing the Electronic Lock

To remove the Electronic Lock, follow these steps:

1. Open the Electronic Lock. For more information, refer to Opening the Electronic Lock.
2. Remove the Lock Assembly by doing the following:
   1. Detach the Lock Assembly from the Security Door by removing three (3) bolts, as shown in the image below.

      

   2. Disconnect the cable from the connector port of the Lock Assembly and then remove the excess cable secured on the bridge lance, as shown in the image below.

      

3. Rotate the Entry Device Assembly at approximately 30° counterclockwise to disengage it from the Dial Plate, as shown in the image below.

   

4. Detach the Dial Plate from the Security Door by removing two (2) screws, as shown in the image below.