Installing the Tri-Light/Lane Light with IP Camera Assembly

To install the new Tri-Light/Lane Light with IP Camera Assembly, follow these steps:

1. Route the LAN Cable into the Tri-Light/Lane Light Pole.
2. Connect the Tri-Light/Lane Light Cable to the cable extender.

   

3. Orient the Tri-Light/Lane Light Assembly so that the Lane Light faces the front of the unit.
4. Insert the Tri-Light/Lane Light Assembly into the Tri-Light/Lane Light Pole. Ensure that the pole holes are aligned.
   Note

   Ensure that the LAN Cable and the Tri-Light/Lane Light Cable do not intertwine when installing the Tri-Light/Lane Light assembly to the Tri-Light/Lane Light Pole.

5. Secure the Tri-Light/Lane Light Assembly to the pole using one (1) screw.

   

6. Route and connect the Tri-Light/Lane Light and LAN cables to the corresponding port destinations:
   Note

   For more information on routing cables, refer to Routing the Cables.

   Tri–Light	Destination Connection (Location)
   Cable Extender	I/O Box (Tri–Light/Lane Light port)
   Ethernet (LAN) Cable	PoE Switch

   Note

   Ensure that the Camera uses an 802.3at (PoE+) compatible Switch/Injector.

7. Attach three (3) Label-Hole Covers to the holes on the Tri-Light/Lane Light, as show in the image below.