Routing the Cables: 7360 R6-C (Card Only)

To route the Tri-Light/Lane Light Cable and LAN Cable in the R6-C Card Only unit, follow these steps:

  1. Do the following:
    1. From the Tower Frame pole duct, route the Tri-Light/Lane Light Cable and the LAN Cable down through the built-in hooks inside the Tower Frame.
    2. Route the cables down the Scanner Bucket floor. Use cable ties to secure the cable on the bridge lances.
    3. Secure the cables to the anchor using a cable tie.

  2. Route the Tri-Light/Lane Light Cable by doing the following:
    1. From the corner cable access hole, route the cable down the Core Cabinet wall and use cable ties to secure the cables on the bridge lances.
    2. Connect the cable to the Tri-Light/Lane Light port of the I/O Box.

  3. Route the LAN Cable. Depending on the unit configuration, refer to the following:

Routing the LAN Cable: No-Bag

To route the LAN Cable, follow these steps:

  1. From the corner cable access hole, route the cable down the Core Cabinet wall and down the bottom exit hole, as shown in the image below.
    Note

    Pass the cable through cable clamps and secure the cable on the bridge lances using cable ties.

  2. Connect the cable to the PoE Switch.

Routing the LAN Cable: Left-Hand Unit

To route the LAN Cable, follow these steps:

  1. From the corner cable access hole, route the cable down the Core Cabinet wall and through the cable access hole, as shown in the image below.
    Note

    Pass the cable through cable clamps and secure the cable on the bridge lances using cable ties.

  2. Continue to route the cable into the Bagwell through the left side exit hole and out through the bottom cable exit hole of the Bagwell.

  3. Connect the LAN Cable to the PoE Switch.

Routing the LAN Cable: Right-Hand Unit

To route the LAN Cable, follow these steps:

  1. From the corner cable access hole, route the cable down the Core Cabinet wall and through the right side exit hole, as shown in the image below.
    Note

    Pass the cable through cable clamps and secure the cable on the bridge lances using cable ties.

  2. Continue to route the cable to the Bagwell and out through the bottom cable exit hole.

  3. Connect the cable to the PoE Switch.