Installing the Tri-Light/Lane Light with IP Camera Assembly

To install the new Tri-Light/Lane Light with IP Camera Assembly, follow these steps:

Note

Ensure that the NCR Customer Helpdesk is informed when the Tri-Light/Lane Light with IP Camera is installed in the store.

  1. Do the following:
    1. Route the LAN Cable into the Tri-Light/Lane Light Pole.
    2. Connect the Tri-Light/Lane Light Cable to the cable extender.

  2. Orient the Tri-Light/Lane Light Assembly so that the Lane Light faces the front of the unit.
  3. Insert the Tri-Light/Lane Light Assembly into the Tri-Light/Lane Light Pole.
    Note

    Ensure the pole holes are aligned and that the LAN Cable and the Tri-Light/Lane Light Cable do not intertwine when installing the Tri-Light/Lane Light assembly to the Tri-Light/Lane Light Pole.

  4. Route and connect the Tri-Light/Lane Light and LAN cables to the corresponding port destinations:
    Note

    For more information on routing cables, refer to Routing the Cables.

    Tri–LightDestination Connection (Location)
    Cable ExtenderI/O Box (Tri–Light/Lane Light port)
    Ethernet (LAN) CablePoE Switch
    Note

    Ensure that the Camera uses an 802.3at (PoE+) compatible Switch/Injector.

  5. Secure the Tri-Light/Lane Light Assembly to the pole using one (1) screw.

  6. Attach three (3) Label-Hole Covers to the holes on the Tri-Light/Lane Light, as show in the image below.