Installing Equinox Luxe 8000i/8500i PIN Pad

To install the Equinox Luxe 8000i/8500i PIN Pad, follow these steps:

Note

For the purpose of illustration only, this procedure shows images using a Standard Configuration unit.

Note

The Equinox Luxe 8000i/8500i PIN Pad is not included in the 7360-K429 No Handle PIN Pad Kit. For more information, contact an NCR Customer Service Representative.

  1. Connect the PIN Pad cable to the RS232/A port of the Primary Terminal Display.
  2. Do the following:
    1. Route the PIN Pad cable down to the back panel opening for the PIN Pad arm.
    2. Route the PIN Pad cable through the cable clamps under the PIN Pad arm and out of the PIN Pad Mount, as shown in the image below.
      Note

      On a Card Only Configuration, route the cable through the PIN Pad arm and out of the PIN Pad Mount.

  3. Turn the PIN Pad over and then connect the cable to the PIN Pad port by pushing the cable at an angle, as shown in the image below.

  4. Press the cable to lock in place and then secure the cable to the PIN Pad using a screw, as shown in the image below.

  5. Mount the PIN Pad to the four (4) studs at the back of the PIN Pad Mount, as shown in the image below.

    Note

    The maximum vertical tilt is 80° and the minimum vertical tilt is 20° as shown in the image below.