Installing the PAX Q25 PIN Pad

To install the PAX Q25 PIN Pad, follow these steps:

Note

For the purpose of illustration only, this procedure shows images using a Full Recycling (Fixed) unit.

Note

The PAX Q25 PIN Pad is not included in the 7360-K440 PIN PadMount (PAX Q25) Kit. For more information, contact an NCR Customer Service Representative.

  1. Connect the PIN Pad cable to the RS232/A port of the Primary Terminal Display.
  2. Do the following:
    1. Pass the PIN Pad cable from the Tower Frame through the corner cable access hole.
    2. Route the cable under the PIN Pad Arm through cable clamps and out to the PIN Pad Mount, as shown in the image below.
      Note

      On a Card Only Configuration, route the cable through the PIN Pad arm and out to the PIN Pad Mount.

  3. Connect the cable to the PIN Pad port.
  4. Attach the PIN Pad on the PIN Pad Mount, as shown in the image below.

    Note

    The maximum vertical tilt of the PIN Pad Plate is 80° and the minimum vertical tilt is 20° as shown in the image below.