Installing the PAX Q25 PIN Pad Mount

Installing the PAX Q25 PIN Pad Mount depends on the unit. For more information, refer to the following:

Full Recycling (Fixed/Convertible) Unit

To install the PIN Pad Mount on a Fixed or Convertible unit, follow these steps:

  1. Attach the PIN Pad Mount to the PIN Pad Arm.

  2. Position the PIN Pad Mount so that its edge is approximately parallel with the Pivot Arm Surface.

  3. Fasten the PIN Pad Mount to the PIN Pad Arm using the Allen key.

Card Only Unit

To install the PIN Pad Mount on a Card Only unit, follow these steps:

  1. Using an Allen key, remove two (2) Allen head screws securing the PIN Pad Plate to the Tilt Arm.

  2. Remove the PIN Pad Plate and rotate it to 180°, as shown in the image below.

  3. Install the PIN Pad Plate on the Tilt Arm using two (2) Allen head screws.

  4. Attach the PIN Pad Mount to the PIN Pad Arm.

  5. Position the PIN Pad Mount so that its edge is approximately parallel with the Pivot Arm Surface.

  6. Fasten the PIN Pad Mount to the PIN Pad Arm using the Allen key.