Installing GSR50 Loader Cassette Lock

To install the GSR50 Loader Cassette lock, follow these steps:

1.Open the Loader Cassette by pressing the green button on the back of the Loader Cassette and then lift the lid.

 

2.Remove two (2) screws to detach the bill guide from the Loader Cassette, as shown in the image below.

Note:  The two (2) hex nuts may fall out of the cassette. Ensure not to lose these nuts.

3.Insert the lock into the cassette lock slot.

Note:  Ensure correct orientation of the key as shown in the image below.

4.Secure the lock by attaching a nut, as shown in the image below.

Note:  Use a 15 mm socket to torque the nut to 3 Nm.

5.Attach the Loader Cassette Cam in a horizontal position to the Lock using a cam screw, and then torque the screw to 2 Nm.

Note:  Ensure correct orientation of the key and the Loader Cassette cam. The Loader Cassette cam must be in horizontal position blocking the latch when the key is in vertical or locked position.

6.Verify the locked and unlocked positions of the key and cam.

7.Attach the bill guide to the Loader Cassette using two (2) screws, as shown in the image below.

8.Close the Loader Cassette by pushing down the lid until it snaps in place.