Tuning the Checkpoint® Antenna

To tune the Checkpoint® Antenna, follow these steps:

1.Verify that the NCR FastLane SelfServ™ Checkout (7364) system and the Checkpoint® Controller are turned on.

2.From the Checkpoint® Controller, remove the Rubber Cover to access the Reset button.

3.Behind the rubber cover panel, press the Press the Reset button. A clicking noise indicates that the controller is tuning the antenna. When the Antenna and Controller are tuned, the Status LED turns off. Only the green power light should be illuminated.

Note:  When the Status LED is Violet, immediately press the Press the Reset button again to tune the Antenna. If the Status LED is Blue, the Antenna and Controller were not successfully tuned. Press the Press the Reset button again.