Installing Bagwell: 7372 Card Only Self-Checkout

To install the 7371-K002 1 Bagwell (No Scale) to the 7372 Card Only Self-Checkout unit, follow these steps:

1. Install the Bagwell Spacer and Stabilizer. For more information, refer to the 7372-K001 Bagwell Spacer (Card Only) Kit Instructions.

2. Partially insert and thread two (2) screws on the Bagwell Spacer, as shown in the image below. Leave approximately ¼ inch of threads exposed.

   

3. Move the Bagwell beside the Core Cabinet.
   Note

   When necessary, adjust the leveling feet to assist in lining up the Bagwell Spacer and Bagwell mounting holes.

   

4. Ensure that the hole on the Base Plate and Bagwell Stabilizer are aligned.

   

5. Slightly lift the Bagwell up and over the partially threaded screws on the Bagwell Spacer.

6. Tighten the three (3) screws to secure the Bagwell.

   Note

   Ensure that the Bagwell does not wobble or rock by placing your hands and exerting moderate pressure on various parts of the Bagwell. Adjust the Leveling Feet, if necessary.

   

7. Place the Bottom Shelf inside the Bagwell, as shown in the image below.