Routing Security Scale Controller Cable: 7372 Card Only Self-Checkout

Depending on the orientation of the unit, refer to the following sections:

The NCR Voyix Self-Checkout units with a Bagging Area (Bagwell) Module can be configured for either Left-hand (LH) orientation or Right-hand (RH) orientation, which refers to the direction customers scan and bag items.

  • Left-hand (LH) orientation—Customers scan from left to right.
  • Right-hand (RH) orientation—Customers scan from right to left.
Note

The orientation of the unit is determined by the position of the Lower Core (Cabinet) Module in relation to the Bagging Area (Bagwell) Module.

Example

The Left-hand (LH) orientation has the unit positioned on the left side of the Bagwell.

Left-Hand Unit

To route the Security Scale Controller Cable in a Left-Hand unit, follow these steps:

  1. From the Bagwell, route the cable down and through the side cable access hole and into the unit.
    Note

    For illustration purposes, the Bagwell Panel (Fascia End) is not included below to show the cable route.

  1. Open the Pedestal Cabinet.
  2. From the side cable access hole, route the cable along the cabinet wall and connect to the R6 I/O Box (Port G).

Right-Hand Unit

To route the Security Scale Controller Cable in a Right-Hand unit, follow these steps:

  1. From the Bagwell, route the cable down and through the side cable access hole and into the unit.
    Note

    For illustration purposes, the Bagwell Panel (Fascia End) is not included below to show the cable route.

  1. Open the Pedestal Cabinet.
  2. From the side cable access hole, route the cable along the cabinet wall and connect to the R6 I/O Box (Port G).