Installation Procedure
To install the Tri-Light Pole Blank, follow these steps:
- Remove the existing Tri-Light/Lane Light Pole, if necessary.
- Unlock the Rear Cover of the Tower Cabinet using a key.
- Remove the Rear Cover from the Tower Cabinet.
- Loosen the thumb screw and slide the Terminal Display up to remove it from the Display Support, as shown in the image below.
- Remove two (2) screws securing the Lower Rear Cosmetic Cover to the Tower Frame.
- Pull up the the Rear Cosmetic Cover to disengage the four (4) hooks from the tabs on the Scanner/Scale Bucket frame.
- Attach the Tri-Light Pole Blank to the Lower Rear Cosmetic Cover using two (2) nuts.
- Attach the Lower Rear Cosmetic Cover to the Scanner/Scale Bucket. Note
Ensure that all four (4) hooks are engaged to the tabs.
- Secure the the Lower Rear Cosmetic Cover to the Tower Frame with two (2) screws.
- Slide the Terminal Display down the Display Support and then secure it using a thumb screw, as shown in the image below.
- Place the Rear Cover on the back of the Tower Cabinet.
- Lock the Rear Cover to the Tower Cabinet using a key.