Installation Procedure

To install the 7371-K150 No-Bag Skirt Panels kit, follow these steps:

  1. On either sides of the Core (Cabinet), do the following:
    Note

    The side skirt panels must be installed before the front and back skirt panels.

    1. Detach the Side Panels from each side of the Core Cabinet. For more information, refer to Removing the side panels from the Core (Cabinet).
    2. Attach the skirt panel to the skirt bracket by aligning the open slots in the skirt panel with the screw holes in the skirt bracket.

    1. Secure each skirt panel to the bracket using two (2) screws.
    2. Adjust the skirt panel so that it is flush with the floor.
    3. Tighten the screws to secure the skirts in place.
    4. Attach the Side Panels on each side of the Core Cabinet. For more information, refer to Installing the side panels on the Core (Cabinet).
  1. On the front or back of the Core (Cabinet), do the following:
    Note

    The front and back skirt panels must be installed after the side skirt panels.  

    1. Attach the skirt panel to the skirt bracket by aligning the open slots in the skirt panel with the screw holes in the skirt bracket.

    1. Secure each skirt panel to the bracket using four (4) screws.
    2. Adjust the skirt panel so that it is flush with the floor.
    3. Tighten the screws to secure the skirts in place.