Removing the PIN Pad (Ingenico ISC250)

To remove the PIN Pad, follow these steps:

1. Turn off the Common Product Name software and hardware systems.

2. Disconnect the PIN Pad device cable.

3. Remove two (2) M4 pan head screws to detach the PIN Pad Mounting Plate Assembly to the PIN Pad Mount, as shown in the image below.

   

4. Slide the PIN Pad Mounting Plate Assembly to the back so that the locator pins are disengaged from the bottom hooks of the PIN Pad mount, as shown in the image below.

   

5. Remove one (1) M4 pan head screw to detach the Ingenico ISC250 PIN Pad from the Front Mounting Plate.