Installation Procedures

To install the Handheld Scanner Mount, follow these steps:

1. Remove the following, if necessary:
   1. Remove the existing Handheld Scanner Mount. For more information, refer to Removing the Handheld Scanner Mount.
   2. Remove the existing Handheld Scanner Arm. For more information, refer to Removing the Handheld Scanner Arm.

1. Insert the two (2) studs of the Adapter Plate into the slots of the Handheld Scanner Bracket and then secure using two (2) nuts, as shown in the image below.

   

2. Mount the Handheld Scanner Holster on the two (2) studs of the Adapter Plate and then secure using two (2) nuts, as shown in the image below.

   

3. Attach the Handheld Scanner Arm to the Tower using two (2) screws, as shown in the image below.

   

1. Attach the Handheld Scanner Mount assembly to the Handheld Scanner Arm using two (2) screws, as shown in the image below.