Setting up the Input Shelf

To set up the Input Shelf (Half Depth - Card Only), follow these steps:

1. Place the two (2) main support bars side by side, as shown in the image below.

   

2. Place the two (2) bottom support bars at each end of the main support bars, as shown in the image below.

   

3. Secure the support bars together using using four (4) M6 flat head screws and M6 nuts.

   

4. Insert the support bar assembly into the Gusset and secure using four (4) M6 flat head screws and nuts.

   

5. Install the Top Shelf on the Plastic Shelf by inserting the studs into the corresponding holes, as shown in the image below.

   

6. Secure the Input Shelf assembly on the Gusset assembly using 10 M6 nuts.