7776-K151 Biometrics

This kit provides a Biometrics for the NCR CX3 POS (7776).

Kit Contents

ItemPart NumberDescription
1Biometrics Assembly
006-8612048Screw, M3x8, Phillips, Pan Head, SEMS, Steel, Zinc
006-8624345Biometrics Module
497-0505874Frame, Side Car
497-0505875Cover, Biometrics
497-0505881Blank, Side Car Bottom
497-0510998Bracket, Retainer, Biometric
497-0511044Cable, 170mm USB with Hirose Connectors
2006-8622623Screw, M4x10, Flat Head, Phillips, Black Oxide

Installation Procedure

  1. Remove the two (2) screws that secure the Back Cover to the Terminal.

  2. If side-mounted peripherals are installed, slowly rotate the Back Cover up from the Terminal to gain access to the peripheral cables and disconnect them from the Motherboard.
    Caution

    When removing the CX3 Back Cover, the peripheral cables must be disconnected from the motherboard before lifting the Back Cover up and away from the terminal. The peripherals are mounted on the CX3 Back Cover and do not have very long connecting cables, therefore extreme caution must be used while lifting the Back Cover up from the CX3 Terminal as to not damage the peripheral cables or motherboard peripheral connectors.

  3. Unhook the Back Cover Tabs to remove the Back Cover.

  1. Route the Cable through the Port B opening.

  2. Hook the Biometrics into the Back Cover and snap into place.

  3. Secure the Biometrics with a screw. Secure the Biometrics with the screw provided (item 2).

  4. Connect the Cable to the Motherboard.

  1. Reinstall the Back Cover.