Configuring the Scanner for Ethernet

1.Configure the scanner by enabling the following:

a.Ethernet

b.Flash at Boot

c.Flash over TFTP

Note:  For program sequences needed to enable these parameters, refer to Programming Worksheets. For procedures on how to enter the program sequences, refer to the Creating the Program.

2.If the scanner is to have a Static IP, configure the following addresses:

a.IP address

b.Gateway address

c.Subnet Mask address

d.TFTP Server address

Note:  For Dynamic IP addressing, the TFTP server address is extracted from the NextServer field in the DHCP discovery process. Locate the Configuration settings (.ini) file in the directory of the installed DHCP server, and then provide the TFTP Server address in the "NextServer" field. If this field is not populated with an IP, the scanner will use the DHCP server's IP as the TFTP server IP address.

3.Reboot the scanner. After reboot, new configurations are automatically applied to the scanner.