Alternate Beep Volume (Parameter #2383, SSI #F8 09 4F)

Note

This feature is used for Not on File events and is supported in RS–232 and NCR CDC interfaces only.

This parameter depends on Enable Alternate Beep Volume (parameter #2384). If Enable Alternate Beep Volume is enabled, the scanner uses the Not on File beep volume set in this parameter. If Enable Alternate Beep Volume is disabled, the scanner uses the default Not on File beep volume and ignores the beep volume set in this parameter.

Scan one of the following bar codes to set the beep volume for Not on File events if Enable Alternate Beep Volume is enabled. By default, this parameter is set to Low Volume.