Extended Same Symbol Timeout (Parameter #2399, SSI #F8 09 5F)
This parameter increases the time for same symbol decoding of GS1 Databar bar codes. It is programmable from 0 to 9.9 seconds, with increments of 100 ms. The default value is 20 (x100 ms), which is equivalent to 2 seconds.
This parameter only takes effect if its value is greater than the standard Timeout Between Decodes, Same Symbol setting (parameter #137). If it is less, the Timeout Between Decodes, Same Symbol setting takes precedence.
To set the Extended Same Symbol Timeout between GS1 Databar decodes for the same symbol, scan the bar code below, and then scan two numeric bar codes from Numeric Bar Codes that correspond to the preferred time. By default, this parameter is set to 20 (x100ms).
Enter a leading zero for single–digit numbers.
To set an Extended Same Symbol Timeout of 0.5 seconds, scan the bar code below, and then scan the 0 and 5 bar codes. To correct an error or change the selection, scan the Cancel bar code in Numeric Bar Codes.
