Over-Capacity Test
The Over-Capacity Test checks for proper indication from the scale when too much weight is placed on the Top Plate.
Note
This test must immediately follow the Increasing Load Test. Do not remove any of the weights from the previous test prior to running this test.
Place additional weight on the center of the Top Plate as shown in the following table. Use the weight that corresponds to the NCR 7895 programmed unit of weight.
Note
Scale capacity is 15 ±0.005 kg or 30 ±0.01 lb. Also, the scale weighs in increments of ±0.005 kg or ±0.01 lb.
For Metric Scales, kg
| Applied Load | Scale Display Result |
|---|---|
| 15.100 kg | EEEE |
For US Scales, lb
| Applied Load | Scale Display Result |
|---|---|
| 30.20 lb | EEEE |
Note
Do NOT remove any weight from the Top Plate after completing this test.
