Loading Files Using USB Staging Flash Drive Menu Options

To clone data and load cloning files to the USB flash drive through menu options on the 7-segment display, follow these steps:

1. Connect the USB flash drive to any of the three NCR 7895 USB ports. The EAS Deactivation button on the front panel turns on and the speaker emits two beeps.
   Caution

   While the staging flash drive is inserted, do not remove power, do not remove nor connect any cables, and do not press the Volume/Tone Control button nor the Scale button. These actions may interfere with the staging flash drive process.

   Note

   If the Sensormatic device is installed and operational, the EAS Deactivation button remains On. If the Sensormatic device is not installed or not operational, the EAS Deactivation button turns on when the NCR 7895 detects the USB flash drive.

2. Wait for the 7-segment display to show 1 (Option 1: Copy an NCR 7895 configuration to the USB flash drive), and then press the EAS Deactivation button. The speaker emits one beep.
   Note

   The flash drive menu displays three number options for approximately five seconds each. When the option you want is displayed in the menu, select the option within five seconds.

3. Confirm the selection within 15 seconds by pressing the EAS Deactivation button again. The 7‑segment display then shows a scrolling bar (–), indicating that the device is working. When the process is complete, the speaker emits three success beeps (high‑low‑high) and the 7‑segment display stops showing the scrolling bar.
   Note

   Take note of the following:

   • If the selection is not confirmed, the speaker emits four fail beeps and the 7‑segment display re-scrolls the menu.
   • The scrolling bar stops whether the cloning process succeeded or failed. If the process failed, try again or contact the System Administrator.