RS‑232 Interface Host Parameters
| Parameter | Parameter Number | SSI Number | Default |
|---|---|---|---|
| RS-232 Host Types | N/A | N/A | Standard |
| Baud Rate | N/A | N/A | 9600 |
| Parity | N/A | N/A | None |
| Stop Bits | N/A | N/A | 1 Stop Bit |
| Data Bits | N/A | N/A | 8-bit |
| Check Receive Errors | N/A | N/A | Enable |
| Hardware Handshaking | N/A | N/A | None |
| Software Handshaking | N/A | N/A | None |
| Host Serial Response Timeout | N/A | N/A | 2 sec |
| RTS Line State | N/A | N/A | Low RTS |
| Beep on <BEL> | N/A | N/A | Disable |
| Intercharacter Delay | N/A | N/A | 0 msec |
| RS-232 Power On Mode | 1939 | N/A | Disable |
| Nixdorf Beep/LED Options | N/A | N/A | Normal Operation |
| Bar Codes with Unknown Characters | N/A | N/A | Send Bar Code With Unknown Characters |
| NCR Use Prefix | N/A | N/A | Enabled |
| NCR Prefix | N/A | N/A | 1002 (STX) |
Note
Take note of the following:
- Parameter number decimal values are used for programming via RSM commands.
- SSI number hex values are used for programming via SSI commands.
