Countertop

Opening the Countertop

1.Turn the black plastic key counterclockwise to unlock the unit.

2.Pull the Countertop assembly from the Bucket until fully extended.

3.For best access to the components mounted on the rear housing, tilt the top of the unit forward.

a.Remove the screw beside the green plunger, one on each side of the unit, and the two screws at the bottom of the Countertop assembly.

! Important:  Keep these screws and re-install them back after service tasks in the rear housing are complete.

b.Pull the green plungers and twist them to a 90–degree angle on each linkage bracket, left and right, then tilt the top of the unit forward until it stops.

Closing the Countertop

1.Pull the green plungers and twist them to a 90–degree angle on each linkage bracket, left and right, then tilt the top of the unit backward until it stops.

2.Secure the unit with a screw beside the green plunger on each side and two screws at the bottom of the Main Chassis assembly.

3.Slide the assembly backward until it locks, indicated by a clicking sound.