BIOS Updating Procedure

Introduction

The BIOS is located in the Serial Peripheral Interface (SPI) chip on the processor board. This chapter discusses procedures on how to update the terminal SPI and/or BIOS. The update software is distributed via the NCR Website.

The BIOS update can be performed using the following methods:

Bootable USB Memory Device

Network – Refer to the NCR PXE Image Loader User’s Guide (B005-0000-2326) for information about this procedure.

Prerequisites

The following are required to perform a SPI/BIOS update using the bootable USB memory key.

USB Keyboard

BIOS Software. Download from the NCR website:

https://www.ncrvoyix.com

1.At this site, select the Support tab.

2.Select Drivers and Patches Retail Support Files
NCR RealPOS and SelfServ Terminal and Operating Systems

NCR RealPOS XR3 (7613-xxxx) BIOS.

3.Select the desired BIOS File.

USB Memory Key Image – Used with USB boot device

Network Image – Used with Network boot

4.Save the software to your local hard drive.