Adding Cards to a Triple Hopper Card Dispenser

1.Remove the Hopper that needs replenishing. Use the green handle bar on the hopper to lift it up from the Card Dispenser.

2.Open the Card Hopper. Lift the Green latch to unlock the cover then rotate the cover forward.

3.Lift the card stack weight from the Hopper.

4.Load new cards into the hopper.

•Magnetic cards—the magnetic stripe must be facing downwards and on the right-hand side (when viewing the dispenser from the front)

•SIM cards— the IC chip must be facing upwards and on the rear side of the card

5.Place the weight on top of the card stack and close the hopper.

6.Mount the hopper on the Card Dispenser.