7746-K152 2D Scanner, Front Mount

This kit provides a front mount 2D Scanner for the NCR PX10/PX15 POS (7746).

Kit Contents

1.Pivot the display toward the back.

2.Remove the screw (1) that secures the Front Neck Cover to the neck.

Note: Use only a screwdriver with a #1 Philips bit to avoid stripping the screw head.

3.Pivot the Front Neck Cover away from the terminal.

4.Lay the terminal face down on a flat surface.

Caution: Always use a soft material (cloth, foam) to protect the display screen when placing the terminal face down.

5.Remove the screws (2) that secure the Rear Base Cap to the Neck.

6.Remove the Rear Base Cap.

7.Set the terminal to stand upright, and then pivot the display toward the front.

8.Pivot the Back Neck Cover away from the terminal.

9.Slightly push the front side of the Stand Top Cover Assembly, and then pivot the cover open.

10.For versions with battery, disconnect the battery cable from the Motherboard.

11.Insert a flat screw driver in the slot to unsnap the Scanner Blank from the display housing.

12.Insert the end of the Scanner flex cable through the opening on the display housing until the cable is visible above the neck.

13.Using tweezers or a plastic hook, pull the cable out of the neck area.

14.Hook the Scanner into the housing and pivot into place.

15.Secure the Scanner using a screw.

16.Route and tape the cable down the left channel of the neck stand.

17.Insert the scanner cable through the opening at the bottom of the neck.

18.Route the scanner flex cable through the routing slot and connect the flex cable to the Motherboard with the blue side facing out.

19.Reinstall the Stand Top Cover.

20.Reinstall the Back Neck Cover.

21.Reinstall the Rear Base Cap.

22.Reinstall the Front Neck Cover.