7746-K243 240GB M.2 SSD

This kit provides a 240GB M.2 SSD for the NCR PX10/PX15 POS (7746).

Kit Contents

Installation Procedure

1.Pivot the display toward the back.

2.Remove the screw (1) that secures the Front Neck Cover to the neck.

Note:  Use only a screwdriver with a #1 Philips bit to avoid stripping the screw head.

3.Pivot the Front Neck Cover away from the terminal.

4.Slightly push the front side of the Stand Top Cover Assembly, and then pivot the cover open.

5.For versions with battery, disconnect the battery cable from the Motherboard.

6.Insert the SSD into the slot on the Motherboard with the label side facing down.

Caution:  Avoid touching the contacts on the bottom or the circuitry on the board.

Note:  If necessary, move the speaker cable down so that it does not block the insertion of the SSD. The speaker cable and RTC battery cable should be routed underneath the SSD.

7.Secure the SSD in place using a screw (1).

8.Reinstall the Stand Top Cover.

9.Reinstall the Front Neck Cover.