7746-K452 Mount for Integrated XL7 Customer Display

This kit provides a mount to install an XL7 Customer Display on the neck of the NCR PX10/PX15 POS (7746).

Kit Contents

Installation Procedure

1.Pivot the display toward the back.

2.Remove the screw (1) that secures the Front Neck Cover to the neck.

Note:  Use only a screwdriver with a #1 Philips bit to avoid stripping the screw head.

3.Pivot the Front Neck Cover away from the terminal.

4.Lay the terminal face down on a flat surface.

Caution:  Always use a soft material (cloth, foam) to protect the display screen when placing the terminal face down.

5.Remove the screws (2) that secure the Rear Base Cap to the Neck.

6.Remove the Rear Base Cap.

7.Set the terminal to stand upright, and then pivot the display toward the front.

8.Pivot the Back Neck Cover away from the terminal.

9.Lay the XL7 display face down on a flat surface.

Caution:  Always use a soft material (cloth, foam) to protect the display screen when placing the terminal face down.

10.Connect the USB-C Cable to the back of the XL7 display. Tighten the thumbscrew.

Note:  Avoid excessive tightening of the thumbscrew. Fully insert the USB-C male connector against the housing and tighten the thumbscrew only until the silver knurled portion touches the black plastic overmold. There should be no gap between the thumbscrew and the overmold, and no looseness in the overmold once the thumbscrew is properly tightened.

11.Insert the opposite end of the USB-C cable through the opening on the bottom of the neck mount.

12.Install the neck mount to the back of the XL7 display using screws (4).

13.Set the PX10 to stand upright, and then pivot the PX10 display toward the front.

14.Attach the neck mount with XL7 display to the terminal.

15. Secure the neck mount and XL7 display assembly on the neck of the PX10 terminal with a screw.

16.Lay the terminal face down on a flat surface.

Caution:  Always use a soft material (cloth, foam) to protect the display screen when placing the terminal face down.

17.Route the USB-C cable through the left side of the neck base and connect the cable to the bottom of the PX10 Stand. Tighten the thumbscrew.

Note:  Avoid excessive tightening of the thumbscrew. Fully insert the USB-C male connector against the housing and tighten the thumbscrew only until the silver knurled portion touches the black plastic overmold. There should be no gap between the thumbscrew and the overmold, and no looseness in the overmold once the thumbscrew is properly tightened.

18.Attach the Rear Base Cap to the bottom of the neck, and secure with screws (2).