Setting Switches
The DIP switches, located at the back of the printer, are used for the following purposes:
•To set variables for several printer functions
•To perform diagnostic tests
For more information on the various diagnostic tests, refer to Level 1 Diagnostics (Setup Mode).
Note: The DIP switches are set to Off.
1.Set the switches to the desired settings shown in the table. Use a paper clip or other pointed object to set the switches.
DIP Switch Settings
|
Switch 1 Settings |
Switch 2 Settings |
Printer State |
|---|---|---|
|
OFF (0) |
OFF (0) |
On-line Mode (default, Standard Model) |
|
ON (1) |
OFF (0) |
Diagnostic Mode |
|
OFF (0) |
ON (1) |
Flash Download Mode / Vendor Adjustment Mode Note: Hold the paper feed button when resting the printer and setting the switches. |
|
ON (1) |
ON (1) |
On-line Mode (4610 Emulation Model) |
2.Reset the printer. For more information about resetting the printer, refer to Resetting the printer.