Installing the Supervisor Switch

To install the Supervisor Switch, follow these steps:

1. Remove 7350 components that must be replaced with R6 Lite Narrow Core components.

2.Open the Core Door.

3.Attach switch assembly cable to the Supervisor Switch port of the IO Box.

4.Route assembly cable up to the core tower.

5.Insert switch assembly into hole in bracket and slide the switch assembly down to hold it in place.

6.Place bracket over the PEM studs on core wall and secure with two nuts.

7.Secure switch assembly in place with black screw cap.

8.Install other R6 Lite Narrow Core components. For more information, refer to the Installation Procedures.