Routing Input Belt DC Power cable in Right-Hand units

To route the Input Belt DC Power cable through the SelfServ Checkout Core Cabinet in a unit with Right-hand (RH) orientation, follow these steps:

1. Install the Input Belt to the SelfServ Checkout. For more information, refer to Installing the Input Belt assembly.
2. Open the SelfServ Checkout Core Cabinet.
3. Do the following:
   1. From the Side Cable Access hole, route the Input Belt DC Power cable along the side wall of the unit and fasten the cable on wire saddles and lance bridges, as shown in the image below.
   2. Connect the Input Belt DC Power cable into the Input Belt/MCR port of the R6 I/O Box.