Routing Input Belt AC Junction Box cable through Left-Hand units

To route the AC Junction Box cable from the Input Belt frame through a unit with Left-hand (LH) orientation and into the store’s power pole, follow these steps:

1. Install the Input Belt to the SelfServ Checkout. For more information, refer to Installing the Input Belt assembly.
2. Open the SelfServ Checkout Core Cabinet.
3. From the Side Cable Access hole, route the AC Junction Box cable along the back wall of the unit, as shown in the image below.

   

4. Do the following:
   1. From the back of the SelfServ Checkout unit, route the AC Junction Box cable into the Bagwell through the Side Cable Access hole and then fasten the cable on a bridge lance.
   2. From the Side Access hole, route the cable out of the SelfServ Checkout unit through the Cable Exit hole at the base of the Bagwell, as shown in the image below.

      

5. Connect the Input Belt AC Junction Box cable to the store’s power pole.