Installing the IP Camera (Premium)

To install the IP Camera (Premium) to the Tri-Light/Lane Light Assembly, follow these steps:

1. Remove the existing Tri-Light/Lane Light Assembly. For more information, refer to Removing the Tri-Light/Lane Light (R6).
2. Connect the LAN cable to the RJ12 port of the IP Camera Controller, as shown in image below.

   

3. Secure the LAN Cable to the Tri-Light Cable Channel Bracket using four (4) cable ties, as shown in the image below.

   

4. Slide the Tri-Light C-clamp Bracket on the new Tri-Light/Lane Light Assembly.

   

5. Slide the Tri-Light Cable Channel Bracket on the new Tri-Light/Lane Light Assembly.

   

6. Secure the Tri-Light Cable Channel Bracket to the Tri-Light/Lane Light Assembly using two (2) screws.