Installation Procedures

To install the PIN Pad Arm, follow these steps:

1. Do any of the following, if necessary:
2. Remove the No PIN Pad Blanking Plate, if the unit was not configured with a PIN Pad Arm. For more information, refer to Removing No PIN Pad Blanking Plate .
3. Remove the existing PIN Pad Mount. For more information, refer to Removing Existing PIN Pad Mount .
4. Remove the existing PIN Pad Arm. For more information, refer to Removing Existing PIN Pad Arm .
5. Secure the PIN pad Arm to the Tower Frame using three (3) screws, as shown in the image below.

   

6. Position the PIN Pad Arm, as shown in the image below.

   

7. Install the PIN pad Mount to the PIN pad Arm and fasten it using the Allen Key.