Installing Lower Bumpers on Bagwell

To install Lower Bumpers on the Bagwell, follow these steps:

Note

This procedure provides instructions for installing the kit on a 3-Bag Bagwell configuration only as an example.

  1. Remove the Back and Front Panels from the Bagwell Frame. For more information, refer to Removing Back and Front Panels from Bagwell Frame.
  2. Remove Hole Cover Labels located on the lower area of the Panels. These Labels correspond to Bumper studs.
  3. Install the Lower Bumper on each Panel by aligning the Bumper studs with the corresponding Panel holes and then secure at the back using lock nuts as shown in the images below.

  4. Install the Lower Bumper on the Side Panel by aligning the Bumper studs with the corresponding Panel holes and then secure at the back using lock nuts as shown in the images below.