Installing Back and Front Panels on Bagwell Frame

To install the Back and Front Panels on the Bagwell Frame, follow these steps:

Note

This procedure provides instructions for installing the kit on a 3-Bag Bagwell configuration only as an example.

  1. Install the Lower Bumpers on the Bagwell Panels. For more information, refer to Installing Lower Bumpers on Bagwell.
  2. Insert the Back Panel to the Bagwell Frame, as shown in the image below.

  3. Insert and secure each Backsplash Holder using one (1) nut to the Bagwell Frame, as shown in the image below.

  4. Install the Backsplash by doing the following:
    1. Insert the Backsplash into the Backsplash Holder slot, as shown in the image below.

    2. Secure the Backsplash to the Core Frame using two (2) flathead screws.

  5. Insert the Front Panel into the Core Frame.

  6. Tighten two nuts to secure the Front Panel to the Bagwell frame.