Setting up the Server

TFTP Server

1.If no TFTP server is currently set up, install a TFTP server.

Note:  The TFTP server used during testing of NCR 7879 was Open TFTP Server (version 1.64). However, this is only a reference server, and customers may select their own TFTP server.

2.Create a file location directory on the server.

Example:  c:\NCR\7879\Firmware

3.Add necessary files to the directory created in step 2. Copy these files from the NCRFlashTool directory (C:\Program Files\NCR\Realscan\NCRRSFlash.

a.NCRFlash.ini

b.0507979.bin — EEUser Definition file for pushing EEPROM

4.Modify the NCRFlash.inifile to have the following settings for FLASHID06 and EEPROMID06 sections:

Note:  For the definitions of these settings, refer to the "The NCRflash.ini File" section of NCR RealScan Scanner Tool Suite Guide (B005–0000–1883).

[FLASHID06]

pushfilename=0508345.bin,n

pullfilename=pulledfile.bin,n

flashoverride=n

sectionoverride=n

 

[EEPROMID06]

pushfilename=neweeprom.bin,n

pullfilename=neweeprom.bin,n

eeuserdefinitionfile=0507979.bin

5.Proceed to Configuring the Scanner for Ethernet

DHCP Server

When using the Dynamic IP addressing, a DHCP server is required.

1.If no DCHP server is currently set up, install a DCHP server.

Note:  The DHCP server used during testing of NCR 7879 was Dual DHCP DNS Server (version 7.12). However, this is only a reference server, and customers may select their own DHCP server.

2.Proceed to Configuring the Scanner for Ethernet.