Installing the System Power Supply

To install the System Power Supply, follow these steps:

1.Remove the existing 7350 components that need to be replaced.

2.Attach the System Power Supply to the Power Supply mount and then secure with a locking screw.

3.Connect the jumper to the System Power Supply.

4.At the back of the Sytem Power Supply, connect the power cable. Ensure the cable is secured to the Retainer Clip.

5.Slide the System Power Supply on the E-Box bracket and then secure with one nut.

Note:  The System Power Supply chassis has hooks on the bottom that are used to hinge the device to the cabinet.

6.Secure the System Power Supply to the cabinet using one screw.

7.Connect the cables to the System Power Supply as shown below.

8.Do any of the following:

•Install the NCR RealPOS XR7 (7702) Display. For more information, refer to Installing the NCR 7702 Terminal Display.

•Route the System Power Supply cables. For more information, refer to Routing System Power Supply Cables.

Note:  For more information about routing cables, refer to the SCO Release 6 Lite Cable Routing Instructions (497-0519586).