Installing the NCR 7702 Terminal Display
To install the NCR 7702 Terminal Display, follow these steps:
Note: To purchase an NCR 7702 Terminal Display, contact an NCR Customer Representative.
1. Remove 7350 components that must be replaced with R6 Lite components.
2.Install the mounting bracket on the back of the Display. For more information, refer to Installing the Display Mounting Bracket.
3.Align the four PEM studs over the holes on the Upper Cabinet Door.
4.Open the Upper Cabinet Door.
5.Insert the Display cables, as indicated in the image below.
6.Secure the Display on the Upper Cabinet Door using four nuts.
7.Install the Display Connector Ports label.
8.Connect cables to the terminal.
9.Route the Display cables. For more information, refer to Routing NCR 7702 Terminal Display Cables.
10.Install R6 Lite components. For more information, refer to the following procedures:
