Routing Ground Strap Cable

To route the Ground Strap Cable into the Core Cabinet, follow these steps:

1.Install the Ingenico Lane 5000 and Axiohm TPOS 58mm mount on the Core Cabinet. For more information, refer to Installing the Ingenico Lane 5000 and Axiohm TPOS 58mm Mount.

2.Install the Ground Strap cable into the stud of the Axiohm Printer Plate and secure it with one nut as shown in the image below.

3.Route the Ground Strap cable by doing the following:

a.Remove the bottom cover of the swing arm.

b.Route the Ground Strap Cable inside the Swing Arm, through the cable clip and into the bottom opening of the Mounting Pole.

c.Inside the Core Cabinet, route the Ground Strap Cable into the back wall and secure it with one nut as shown in the image below..

Note:  Secure cable using cable ties.

4.Route the Ingenico Lane 5000 and Axiohm Printer cables. For more information, refer to Routing Ingenico Lane 5000 and Axiohm TPOS 58mm Cables.