Routing NCR 7702 Terminal Display Cables

To route the Display cables in the NCR SelfServ Checkout unit, follow these steps:

1.Install the Terminal Display. For more information, refer to Installing the NCR 7702 Terminal Display.

2.Using cable ties, secure the cables on the Supervisor Switch bracket and then route the cables down into the back of the unit through the hole in the base mount.

Note:  The Supervisor Button cable is also routed with the Display cables.

3.Do any of the following:

•Install other R6 Lite Narrow Core components. For more information, refer to Installation Procedures.

•Route and sort cables. For more information, refer to Routing and Sorting Cables.

Note:  For more information about routing cables, refer to SCO R6 Lite (Narrow Core) Routing Instructions (497-0520486).