Installing the I/O Box and Power Supply Bracket

To install the I/O Box and Power Supply Bracket (I/O Box-PSU Bracket) to the NCR SelfServ Checkout Narrow Core unit, follow these steps:

1.Do the following:

•Install the System Power Supply on the I/O Box - PSU bracket. For more information, refer to Installing the System Power Supply on Bracket.

•Install the I/O Box on the I/O Box - PSU bracket. For more information, refer to Installing the I/O Box on Bracket.

2. Slide the bracket assembly to the hooks on the core floor to lock the bracket in place and secure the bracket to the core wall using two screws.

3.Do any of the following:

•Install other R6 Lite components. For more information, refer to the Installation Procedures.

•Route the cables. For more information, refer to Routing and Sorting Cables.

Note:  For more information about routing cables, refer to SCO R6 Lite (Narrow Core) Routing Instructions (497-0520486).