Routing Input Belt Cables

To route the Input Belt cables through the SelfServ Checkout Core Cabinet, follow these steps:

1. Install the Input Belt to the SelfServ Checkout. For more information, refer to Installing the Input Belt assembly.
2. Do the following:
3. Route the Input Belt DC Power cable to the SelfServ Checkout R6 I/O Box. Depending on the unit orientation, refer to any of the following procedures:
   • Routing Input Belt DC Power Cable in Left-Hand units
   • Routing Input Belt DC Power cable in Right-Hand units
4. Route the Input Belt AC Power cable to the SelfServ Checkout Power Strip. Depending on the unit orientation, refer to any of the following procedures:
   • Routing the Input Belt AC Power Cable in Left-Hand units
   • Routing the Input Belt AC Power Cable in Right-Hand units
5. If the Input Belt comes with an AC Junction Box, route the AC Junction Box cable through the SelfServ Checkout and out to the store’s power pole. Depending on the unit orientation, refer to any of the following procedures:

• Routing Input Belt AC Junction Box cable through Left-Hand units
• Routing Input Belt AC Junction Box cable through Right-Hand units
  Caution

  Do not plug the cable into the UPS or into the same circuit as the NCR FastLane SelfServ™ Checkout unit.